Principle of operation of the apparatus

When a liquid is flowed in from the connection side, a swirling flow is formed and bubbles gather at the center of the device taper chamber flow end. A back pressure device is provided on the outflow side of the device, which gives back pressure and discharges the assembled air bubbles from the vent valve.
Collection status of bubble The situation where bubbles actually gathered.

 

 

DEVICE SETTING METHOD

PUMP DISCHARGE SIDE INSTALLATION

The mounting position is free, and the pump suction side cannot be installed. It cannot be used under high pressure (high pressure specification is possible).
(Note) By placing a valve on the suction side of the pump, the gas in the fluid can be deposited as bubbles and removed to reduce the gas solubility.
(This method may not be possible depending on the liquid.)

BUILT IN PIPELINE

About 0.1~0.15MPa is required as the pressure margin on the inflow side of the bubble removal device. Series connection with filters and coolers is possible.